Aiwa NSX-D70 - Manual (Page 11)

11
En
Programmed playback
Plays back up to 30 selected tracks in programmed order.
1 Press SHIFT+PROGRAM on the remote control
during stop.
"PRGM" flashes on the display.
2 Press CD DIRECT on the remote control and then
press the numbered button (1-3) within 3
seconds to select a disc.
Go to the next step when the tray stops rotating.
3 Press the numbered buttons on the remote
control to program a track.
The selected track number lights up on the display.
- To select the 25th track, press +10, +10 and 5.
- To select the 10th track, press +10 and 0.
4 Repeat step 2 and 3 to program other tracks.
5 Press c.
•During programmed playback, you cannot select a disc or a
track with the numbered buttons. "CAN'T USE" is
displayed when you try to select a track .
•If the total playback time of the program exceeds 99:59
minutes, or if a track with a track number exceeding 30 is
programmed, the playing time is displayed as "- -:- -".
•You cannot program more than 30 tracks. "FULL" is
displayed.
To check the program
Press f or g repeatedly during stop. The track number
and program number are displayed in succession.
To clear the program
Press s during stop. "PRGM" disappears on the display.
To add tracks to the program
Repeat step 2 and 3 before starting playback. The tracks are
added to the end of the program.
To change the programmed tracks
Clear the program and reselect the tracks in your desired order.
Notes on CDs
•Do not place more than one disc on one tray.
•Do not tilt the unit with discs loaded.
•The unit may not play a CD-R/RW disc recorded on personal
computers or certain kinds of CD-R/RW recorders.
•Do not attach adhesive label, etc. to either side of a CD-R/
RW disc, as doing so may cause malfunction.
•Do not load an unrecorded CD-R/RW disc. The disc may be
damaged.
•Do not use irregular-shaped CDs.