Aiwa NSX-D70 - Manual (Page 14)

14
En
TAPE OPERATIONS
Playback
Use only type I (normal) tapes.
1 Turn the Dial Function to select the TAPE function.
2 Press zPUSH EJECT/CLOSE on either side
(DECK 1 and DECK 2) to open the outer cassette
holder and insert the tape in the deck.
Insert with the exposed side down and playback side facing
out from the unit. To close, push zPUSH EJECT/CLOSE
on the side where the tape is inserted.
3 Press c.
To open the inner cassette holder
The inner cassette holder opens or closes automatically when
opening or closing the outer cassette holder. If the outer
cassette holder is already open, press zPUSH EJECT of the
inner cassette holder to open it.
To open or close both decks (DECK 1 and DECK 2)
simultaneously
Press or push zPUSH EJECT/CLOSE on both sides of the
outer cassette holder simultaneously.
To stop playback
Press s.
To pause playback (DECK 2 only)
Press a. Press again to resume.
To fast forward or rewind
Press f or g.
To select a deck (DECK 1 or DECK 2)
Press DECK 1/2 in stop mode when tapes are loaded in both
decks. The deck number ("T1" or "T2") is displayed.
To reset the tape counter
Press s in stop mode, and the tape counter on the display is
reset to "0000". Opening and closing the cassette holder
will also reset the tape counter.
To play continuously (DECK 1 to DECK 2 )
Load tapes in both decks and start playback on DECK 1. Then,
as soon as playback on DECK 1 finishes, playback on DECK
2 will start without interruption.
• The both decks play one side of the tapes.
To play back type II (High position) tapes
Turn MULTI JOG until "SOFT" is displayed while playing a
type II tape.
The unit automatically sets the graphic equalizer to appropriate
levels to provide the optimum playback sound for type II tape.
The "SOFT" function works even after the unit is turned off or
the function is changed unless it is canceled.
To cancel it, cancel the graphic equalizer (see "SOUND
ADJUSTMENT").
Notes on cassettes
• Use of 120-minute or longer tapes is not recommended
since they are extremely thin and easily deformed or
damaged.
• Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may jam in the mechanism.
Basic recording
Use only type I (normal) tapes. DECK 2 is the recording deck.
Only one side of the tape can be recorded at a time.
1 Insert the recording tape in DECK 2.
Press zPUSH EJECT/CLOSE to open the outer cassette
holder, and insert with the exposed side down and the
side to be recorded on facing out from the unit.
Wind up the tape to the desired point if needed.