Aiwa NSX-D70 - Manual (Page 18)

18
En
TIMER OPERATIONS
Sleep timer
Turns off the unit automatically after a specified time.
1 Press SHIFT+SLEEP on the remote control.
"SLP" appears on the display.
2 Press f or g repeatedly to set the sleep
timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to 240 minutes. If there is no button input
for 4 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
• MULTI JOG is also available in place of f or g.
Tip:
The display is dimmed while the sleep timer is active.
To check the remaining time until the unit turns off
Press SHIFT+SLEEP on the remote control. The remaining
time is displayed for 4 seconds.
To cancel the sleep timer
Press SHIFT+SLEEP twice on the remote control so that "SLP
OFF
" is displayed.
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Press TIMER (SHIFT+TIMER on the remote
control).
"5" indicator lights up and " PLAY" appears on the
display. Then, the timer-on time and the source name
appear alternately on the display.
2 Press f or g to set the timer-on time, then
press ENTER or aSET.
If f or g is not pressed within 6 seconds, you
will exit the timer setting mode and the previous setting,
however, is entered.
3 Press f or g to select the source, then
press ENTER or aSET.
4 Press f or g to set the timer-activated
duration, then press ENTER or aSET.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
5 Press f or g to adjust the volume level,
then press ENTER or aSET.
Adjust from 0 to 26.
6 Prepare the source.
To play CD(s), load disc(s).
To play the radio, select the band and tune in to the desired
station.
To play a tape, insert the tape and select the deck.
To play external equipment connected to the VIDEO/AUX
jacks, set an external timer for the equipment so that its
playback begins at the same time.
7 Press POWER 6STANDBY/ON to turn the unit
off.
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
Tip:
The display is dimmed while the timer playback is active.
• To stop timer setting in steps 2 to 5, press s.
Timer standby mode is also canceled.
• Timer playback will not begin unless the unit is turned off
first.
• Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
• MULTI JOG is also available in place of f or g.
• In step 3, FUNCTION or Dial Function is also available to
select the source.
In step 5, VOLUME +, - or VOLUME is also available to
select the source.