SIGMA RC 14.11 - Manual (Page 35)

83
US/GB
7 TRAINING MODE
Synchronization
If you start the training mode, the RC 14.11
reconnects to the R3 transmitter; it is synchronized.
During the synchronization, “SYNC” appears on
the display. The synchronization is complete, when
“SYnC” is no longer shown on the display.
Message “Too many signals”
This message appears when there are too many
transmitters in the vicinity. In order to resynchronize,
proceed as follows:
1 move about 10 m away from possible sources of
interference, such as other heart rate monitors,
power lines and antennas.
2 Press any button to remove the message.
3 Press and hold the SPEED (+) button until
“Radio link reset” appears on the display.
The R3 transmitter and the RC 14.11 are
now re-synchronized. If the synchronization
is successful, the training mode is displayed
normally again.
Note: The RC 14.11 cannot be disturbed after
a successful synchronization
Press the START/STOP button. The running time
begins.
A stopwatch icon appears at the bottom of the
display and the name of the measured value has
a light background.
Prerequisite: Your running computer must be in
training mode.
7.6 STARTING A TRAINING SESSION