Telenav for AT&T Supported Devices: v3.9 Lite for Motorola SLVR L6, L7, RAZR V3i Users Guide - Manual (Page 13)

© TELENAV 2003-2007 PAGE 13 OF 23
If you are using real time GPS navigation guidance, make certain that your
Bluetooth GPS receiver is powered ON. The TeleNav application will take a few
moments to scan all nearby Bluetooth devices to get an up-to-the-minute GPS
location fix, followed by a network transaction while the phone sends the fix and
destination address to the TeleNav servers that respond with the routing data.
GPS Guidance Instructions
Within a few seconds, TeleNav will contact the TeleNav server, obtain an optimal
route to your destination, and display the first instruction telling you how to start
your trip from your current location. These displays are described below under
Guidance Displays.
If your Bluetooth GPS receiver is not powered ON, the battery is low, or the
receiver is located too far away from your mobile phone, a message similar to that
at the right will appear. Please power the Bluetooth GPS receiver ON, connect it to
a charger, or place is closer to your mobile phone and try again.
GPS Origin Refinement
If are using GPS Navigation and you are in a parking lot or similar area where your
location does not exactly match a specific street, you may see a pop-up that shows
TeleNav’s best estimate of which street you are on, and you are allowed to change
it. If you elect to change the starting street, a list of neighboring streets will be
presented, and you can make an alternate selection from the list. If you do nothing,
the first pop-up will disappear after a few seconds.
NOTE: If you are not sure of the street you are on, simply start driving. TeleNav
will revise its estimate of your location, and provide you with a new route if needed.
I found you on -
Cooper Drive
< 5 secs >
OK CHNGE
NOTE: Unless you are moving, the GPS will not provide TeleNav with your direction of travel. If this is the case, the
first few guidance instructions may be incorrect since TeleNav may make an incorrect assumption. However, once
you start moving, TeleNav will learn your direction of travel and provide a corrected set of guidance instructions.
Guidance Displays
The guidance instruction screens you will see have the following content, but will have different proportions than those
shown below. GPS navigation and Non-GPS directions screens have slightly different content as explained below.
When TeleNav is communicating with the TeleNav servers, a network activity indicator replaces the GPS indicator
shown in the lower right corner of the screen.