APW Wyott VCG - Manual (Page 12)

7. PREVENTATIVE MAINTENANCE SCHEDULE
Tools required: Heat Resistant Gloves, Standard Cleaner, Standard Sanitizer, Soft Towels.
Needle Nose Pliers, Soft Brush
Phillips Screwdriver, Standard Lubricating Oil
1) Preventative Maintenance -
Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves
when removing the top cover, cleaning the Release Sheet, and cleaning the silicone belt.
A. Exterior. Everyday you should clean the outside of the toaster by wiping it down with a
soft cloth and detergent.
B. Cooling Fan. Check air intake. The cooling fan grille on the side of the toaster must be
cleaned daily clean grille with a stiff nylon type brush. The cooling fan operates when
the power switch is turned to on. It must operate to keep the electrical control compartment
below 140°F (60°C).
If the fan blade is not rotating, or fan assembly is missing from main blower
motor shaft, do not operate toaster. Serious damage could be done to the blower motor and /
or the solid-state electrical components if the toaster is operated while the cooling fan is not
running or if the cooling intake is blocked.
C. Additional cleaning according to the instructions described on page 7 & 8.
D. Remove the top cover and bun chute and clean in a sink.
E. Remove the release sheet and wipe clean with a damp cloth. Be careful not to crinkle it
or rip it at the crease. Be careful when removing it since it might still be hot.
2) Preventative Maintenance -
Toaster may be hot. Allow to cool before cleaning. Use heat resistant gloves
Daily:
Monthly:
Yearly:
Daily
WARNING!
WARNING!
Weekly
WARNING!
when removing the top cover, cleaning the release sheet,
and cleaning the silicone belt.
A. Clean Silicon Belts. In addition to the daily cleaning
described above, remove the top cover. Open one side
(front or rear) of the toaster and clean the orange silicone
belt. Using a standard cleaner, wipe across and down.
Clean both sides of each silicone belt. To rotate the belt,
depress the safety interlock switch located on the top of the
toaster.
Do not allow articles of clothing, hands,
fingers, or any foreign objects from being caught in the
rotating conveyor belt. To stop the conveyor from turning,
release the safety interlock switch.
Follow cleaning by wiping down both sides of each silicone
belt with a standard sanitizer. Turn the toaster on the
counter to access the other silicone belt, and repeat the
cleaning instructions.
B. Clean Release Sheets. Carefully remove the Release
Sheet, laying it flat on a clean surface. Using a standard
cleaner, wipe down both sides of the sheet until clean.
Follow cleaning by wiping down both sides of the sheet
with a standard sanitizer. If the Release Sheet appears to
be overly worn, replace it.
WARNING!
Cleaning Silicone Belt
Cleaning Release Sheets