APW Wyott VCG - Manual (Page 14)

"
5) Preventative Maintenance
A. In addition to the daily cleaning described above, remove the silicone belts according to the
instructions described in (3), and inspect the metal conveyor chain. Check the tension to
make sure that drive sprockets are engaging all the wires in the metal conveyor chain. If the
sprockets are not engaging all the wires, if the metal belt is too loose, making noise, or
exhibits any other indication of being unusually loose, call an authorized APW Wyott Service
Technician.
AN ANNUAL PREVENTATIVE MAINTENANCE INSPECTION OF THE
INTERNAL COMPONENTS IN YOUR TOASTER WILL EXTEND THE PRODUCT'S LIFE
AND ASSURE PROPER LONG TERM PERFORMANCE. PREVENTATIVE
MAINTENANCE OF THE INTERNAL COMPONENTS IS A RECOMMENDED
PROCEDURE THAT MUST BE COMPLETED BY A KNOWLEDGEABLE TECHNICIAN,
SUCH AS AN APW WYOTT AUTHORIZED SERVICE TECHNICIAN. PREVENTATIVE
MAINTENANCE IS THE RESPONSIBILITY OF THE OWNER, AND IS NOT COVERED
UNDER THE WARRANTYAGREEMENT PROVIDED WITH THE TOASTER.
B. Open the right side panel by removing the Phillips screws with a screwdriver, and
inspect the drive chain and motor. DO NOT DISCARD THE SCREWS.
Inspect the drive chain. Lubricate the chain by applying a few drops of standard lubricant to
the chain and internal idler sprocket.
Inspect the drive motor. Lubricate the motor by applying a few drops of standard lubricant to
the hole in the outer metal flange that contains the motor's drive shaft.
Yearly
CAUTION.
WARNING! Electrical hazards are present inside the toaster's right side panel. THE
TOASTER MUST BE UNPLUGGED BEFORE THE SIDE PANEL IS REMOVED. ONLY
AN EXPERIENCED / AUTHORIZED EMPLOYEE OR SERVICE AGENT PROPERLY
TRAINED IN MAINTAINING ELECTRICAL EQUIPMENT SHOULD BE REMOVING THE
RIGHT SIDE PANEL.