APW Wyott VCG - Manual (Page 18)

Turn the screw counter clock-wise about a half turn. If the belt has walked over the right
sprocket, you will need to put it in the center of the sprockets by hand. CAUTION!!! THE
BELT MAYBE EXTREMELYHOT.YOU COULD BURNYOURSELF.
No
No
No
No
Yes
Yes
Yes
Yes
Did the belt walk
off the sprocket
in 5 minutes?
Did the belt walk
off the sprocket
in 5 minutes?
Has the belt
walked over
one of the
s p r o c k e t s
w i t h i n 1 0
minutes?
Start
END
Position yourself so that you face the conveyor with the access cover
between you and the conveyor. The platen should be on the other side
of the conveyor from you.This puts the adjustment screw on your right.
Continue to monitor the
conveyor from time-to-
time for a couple of days
to see if it walks over a
sprocket.
Did the conveyor
belt walk after a
few hours?
T o w h i c h
sprocket did
the belt walk
over?
Left
Left
Right
Right
While conveyor
b e l t i s s t i l l
b e t w e e n t h e
sprockets, turn the
screw 2 times
clock-wise.
While conveyor
belt is still
between the
sprockets, turn
the screw 2
times counter
clock-wise.
Within about 5
minutes, which
sprocket is the
conveyor walking
toward?
Turn the screw clock-
wise about a half turn. If
the belt has walked over
the right sprocket, you
will need to put it in the
center of the sprockets
by hand. CAUTION!!!
THE BELT MAY BE
EXTREMELY HOT. YOU
C O U L D B U R N
YOURSELF.
Neither. It stays
in center.
TOOLS NEEDED: Needle-nose pliers, phillips-head screwdriver.
1. Turn off toaster. Let cool for 30 minutes.
2. Remove top lid and open front cover.
3. Turn toaster on and depress top lid switch button until the belt splice
(flap) is at about the center of the conveyor. Turn toaster off.
4. Remove the pin from the splice using the needle-nose pliers.
5. Remove the old belt from the toaster. (CAREFUL!!! MAY BE HOT! YOU
COULD BURN YOURSELF!)
6. Put the new belt on. Feed the belt through the conveyor using the end
of the belt without the flaps. (CAREFUL!!! MAY BE HOT! YOU
COULD BURN YOURSELF!)
7. Put pin in splice. Make sure sides of belt are aligned and that belt is
routed over the plastic roller. Make sure belt is in center of conveyor.
8. Close the front cover and turn to the rear conveyor.
9. Repeat steps 3-7 for rear conveyor.
10. Close the rear cover and replace the lid.
11. Turn toaster on and turn knobs to their normal settings.
12. Watch the conveyors to see if belts ride over the sprockets. If they do,
follow procedure for training a belt (see section 10, pages 17-18).
11. PROCEDURE FOR CHANGING A BELT
PROCEDURE FOR BELT ADJUSTMENT (TRACKING)
&