AltiGen comm 705 - Manual (Page 24)

16 IP 705 Manual
4. Configure the AltiWare IP settings (see “Configuring IP Settings” on
page 22 for information about IP settings):
a. Menu > SYSTEM >Enter.
b. Select AW SERVER, and press Enter.
c. Enter the AltiWare server address, using the * key to input periods,
and press Enter.
5. Activate the IP 705 extension from the IP phone:
a. With the handset onhook, press #27, then the Enter button.
b. Enter the extension number and password when prompted.
c. The phone will attempt to register, as shown in the LCD screen:
If the phone successfully passes through these stages, the phone
shows the date, time, and extension in the LCD screen and is now in
normal operating mode.
If it doesn’t pass through these stages successfully, refer to
“Troubleshooting” on page 43.
The Phone Startup Process
After the IP 705 has power connected to it, the phone begins its automatic
booting process by cycling through these steps:
1. All LED lights will be on.
2. The LCD screen displays [ATGN BOOT] on the first line.
3. On the second line of the LCD screen, the following messages are
displayed in succession:
—CHECK MEMORY (RAM checking state)
—CHECK FW (Firmware checking state)
—INIT NETWORK
01/12 x300