AltiGen comm 705 - Manual (Page 26)

18 IP 705 Manual
Miscellaneous Operation Notes
• Logging in and out—When using #26 and #27 to log out / log in, the
IP 705 must be onhook. Pressing the Speaker button and then using
#26 or #27 will not work.
• BASIC mode—If the IP 705 phone fails to register with AltiWare
during startup, the phone operates in Basic mode. When in Basic
mode, the IP phone’s LCD display shows (BASIC) IDLE.
No AltiWare switching features are available in this operating mode.
However, the phone user can enter a destination IP address followed
by #, and make an outgoing call through the IP network to reach
AltiWare or another IP 705 phone. Also, the IP phone can accept
incoming calls originating from AltiWare or another IP 705 phone.
If the IP phone’s local configuration is changed while in BASIC
mode, the changes are overridden by AltiWare Administrator
settings.
• Incoming call takes priority—If a call comes in while you are using
any phone menu or display (such as workgroup display or Call Log),
the phone will exit the menu and go to the ring state.
• Restoring default settings—To automatically restore the original
default settings for the IP 705 phone:
1. Press the Menu button.
2. Press * * 2, then press the Enter button.
• Rebooting the phone—To reboot the IP 705 phone, press * * 3, then
press the Enter button.