AltiGen comm 705 - Manual (Page 25)

Setting Up the IP 705 Phone
IP 705 Manual 17
—LOADING FW...
—LOADING NOW.
—Boot Done
—INITIALIZING
—Version xxxx.xxxx.xxxx
To Use IP 705 in Power over Ethernet Mode
1. Unplug the power cord.
2. Remove the screw on the PoE Module cover, and remove the cover.
3. Plug in the PoE Module as illustrated below. The side with four pins
in the center faces the right side.
4. Put the PoE module cover back, and tighten the screw.
5. Move the DC/PoE switch to the PoE position.
6. Connect the phone to an AltiGen-certified PoE-enabled switch.
To Remove the PoE Module
1. Remove the screw on the PoE Module cover, and remove the cover.
2. Notice the “feet” on the two tabs located on the lower end of the
cover. Use these feet to lift the PoE module out of the compartment:
Holding the upper end of the cover, slip the cover into either the right
or left side of the module compartment, between the compartment
and the module, until the feet of the two tabs is under the module (the
inside of the cover should be facing toward the module).
3. Pull up to remove the module.
Right
Left