Monoprice PID 8742 Wireless 802 11N Router with Internal Antenna and WPS Function 2T2R MIMO 300Mbps - Manual (Page 28)

23
service or you want to use the router to expand your wireless signal coverage.

SSID: SSID (Service Set Identifier) is the identity of the wireless device. You can only
access the ISP's network by entering the correct SSID of the ISP's wireless device.
You can click the Open scan button to let the router automatically search for any
available SSIDs. The SSID can also be the SSID of the primary wireless device
when using the router as a wireless bridge.

MAC: To connect to the ISP's wireless device you need to know the device's MAC
address. You can click the Open scan button to let the router automatically search
for an available MAC address or the primary wireless device's MAC address.
 Channel: The wireless device's communication channel. You must select the same
channel as the ISP's wireless device to enable communications. It can also be
scanned by clicking the Open scan button.
 Security mode: When the ISP wireless device is secured, the access device should
set the same security mode, encryption mode, and key as the ISP's wireless device.
Example:
If your ISP's wireless device's SSID is Wireless then just enter Wireless into the SSID field,
plus the wireless MAC address and channel into the corresponding fields of the above
picture. If the ISP device is secured, set your router's encryption type to the same as used
by the ISP's device. Alternatively, you can click the Open scan button to let the router
automatically fill in the SSID, Channel, and wireless MAC. After saving these values, go to
the WAN Setting screen to select the corresponding WAN connection type to complete the
configuration.
4.7 Bandwidth Control
Bandwidth control is used to limit the communication traffic of LAN computers when
accessing the Internet. It can simultaneously control the traffic for a maximum of 254 PCs.
Additionally, IP address range configuration is also supported.