Monoprice PID 8742 Wireless 802 11N Router with Internal Antenna and WPS Function 2T2R MIMO 300Mbps - Manual (Page 33)

28
refresh automatically every five minutes.

IP address: the IP address of the computer whose traffic is being calculated.

Uplink rate: the data sending speed per second in KBytes/s.

Downlink rate: the data receiving speed per second in Kbytes/s.

Sent message: the number of data packets sent out through the router.

Sent Bytes: the total volume of data that is sent out through the router.

Received message: the number of data packets received through the router.
 Received Bytes: the total volume of data received through the router.
4.9 WAN Speed
This section allows you to configure the WAN speed. It is recommended that the default
settings are retained.

AUTO: This is the default setting. In this mode, the router will select the best data
speed for your network. Keep this selection unless you are experiencing connection
and performance issues.

10M HALF-duplex: This is the slowest data rate. Select this value if your router's
WAN port does not function properly when connected to an Ethernet cable, which
may be caused by degraded performance due to the cable's excessive length.

10M FULL-duplex: Select this value to improve WAN port performance.

100M HALF-duplex: Choose this selection it to set the router's WAN port to work at
100Mbps in half duplex mode.

100M FULL-duplex: This is the fastest data rate. Select this value to force the WAN