Monoprice PID 8742 Wireless 802 11N Router with Internal Antenna and WPS Function 2T2R MIMO 300Mbps - Manual (Page 52)

47
Chapter 8 Security Settings
8.1 Client Filter Settings
You can enable client filtering to control a client computer's access to specific ports of the
internet.
 Filter Mode: You can select either Permit only or Forbid only.
 Access Policy: Select an unused number from the drop-down list.
 Remark: Input a simple description of the configured filter rule (you may leave it
blank if you wish).
 Start/End IP: Enter the Start IP and End IP address range.
 Port: Enter the range of ports to be controlled. The two values may be the same,
indicating a single port rather than a range of ports.
 Type: Select a protocol type (TCP, UDP, or Both) from the drop-down list.
 Time: Select the starting and ending time range for the filter to be in effect.
 Date: Select the starting and ending day(s) to apply the access policy.
 Enable: Check the Enable box to apply the filter after clicking the Ok button.