Racing Electronics SC200 User Manual
Page 36
CTCSS and DCS begins flashing in display.
The scanner starts searching for an associated CTCSS
tone or CDCSS tone when it stops on a transmission. All
tones are checked if the transmission is long enough.
However, if you press
,and there is break before a
tone is identified, the tone search starts where it left off
when the transmission begins again.
3.
If a CTCSS tone is found, the tone begins flashing in the
display.
4.
Press
to program the tone with the frequency
stored in the channel.
-- OR --
Send the frequency with its associated tone to another
channel.
For information about sending a frequency to another
channel, see Programming Channels on the page 19.
5.
Restart the search and repeat Steps 3 - 4 to search for
tones associated with other frequencies in the search
range you set in Step 1.
34