Racing Electronics SC200 - Manual (Page 49)

Care and Maintenance
Replacing the Battery Pack
1. Turn the On-Off/Volume Control OFF.
2. Turn the scanner over
so you are looking at
the back. If the belt
clip is attached,
remove it by taking out
the two screws.
3. Press in on the ribbed
area and slide the
battery cover down and
off.
4. Carefully unplug the battery pack and lift it out of the
case. You may need to exert slight pressure toward the
top of the scanner as you slide the battery pack out of
the case.
5. Carefully plug in the new battery pack, observing the
proper polarity. (The RED wire should be on the upper
side as you plug it in.) Although the plug is keyed to
reduce the chance of inserting it in wrong, make sure
the wires are in the correct position before pushing it in
all the way. DO NOT FORCE THE PLUG.
47