Racing Electronics SC200 User Manual
Page 43
6.
If the connection is successful, the scanner starts
clearing the memory. And during that period,
will appear for 12 seconds.
7.
After clearing the memory is over, the scanner starts
downloading the frequency.
8.
will be displayed when your downloading is
completed.
9.
To start the scanner, you must turn the unit off/on.
If downloading is not successful, one of the following error
messages will appear.
“Modem Err”: Modem Access Error
“No Carrier”: Receive No Carrier message from modem
“Busy”:
Receive Telephone line busy message
“No Answer”: Receive No Answer message from modem
“Error End”:
Quit access line by server
“Timeout”:
Non data receive time out
NOTE: If the scanner does not display
Loading
(see
step 7), disconnect the access by pressing
. Then, make
sure the modem is connected properly, and try again.
NOTE: If the scanner’s display locks up or does not work
properly after you connect power, you need to turn the
scanner off then on again.
41