Racing Electronics SC200 - Manual (Page 48)

2. Determine the scanner that has the frequency data that
you want to transfer. This one must be set up as the
“Master Unit”, and the other must be set as the “Slave
Unit”.
3. On the scanner that is the” Master Unit”, press the
or key until appears in the display.
4. On the scanner that is the” Slave Unit”, press the
or key until appears in the display.
5. Press the key on both scanners. The data
transfer is started from the Master Unit to the Slave Unit.
During the data transfer, and characters
will continue to flash.
When the data transfer is completed, displays.
If the data transfer is not successful, the following error
message will appear.
46