Vaisala Spectrum 4.0 - Manual (Page 36)

Getting Started
30
value to show as 1, indicate 1 for Above Threshold and specify the units.
Boolean choices are typically 1 (above threshold) and 0 (below threshold).
5. Click OK.
Configuring Warm Up Time
Note: This section only applies to Veriteq SP-4000 data loggers.
Some SP-4000 data loggers have the ability to switch power from an external
battery onto a transducer using the Warmup Time feature, also known as the
XPS excitation control switch. This is useful for conserving power when an ex-
ternal transducer is being powered from an external battery.
Set transducer warm up time to a number of minutes or seconds before data is
recorded by the data logger. To set when the data logger will record data, see
Setting the Data Logger Sample Timing on page 22.
To configure transducer warmup time:
1. Choose Logger>Setup.
2. From the row for the channel you want to set up the warm up time for, click
Setup.
3. From the Setup Channel screen, click Warmup Time.
4. From the Warmup Time screen, select the Timer radio button.
You can also set up warmup time from the Logger Setup window.