Summers Disk-Chisel - Manual (Page 35)

WING & CYL ATTCH 8/13/2012 9DC4012.iam/
16
9"
(32
'-36
')
217
"
(40
')
8T3600
8C6015
8X0234
7/16" LNUT
8X0044
7/16" X 3-1/2"
8CC5050
8X0112
3/4X2-1/4"
8K5515
3/4 X 4 X 6"
8X0306
3/4" LW
8X0260
3/4" N
8X0306
3/4" LW 8X0260
3/4" N
8CC4080
8T4224
LEFT
8CC5052 RIGHT
LEFT
8CC4082 RIGHT
(40' ONLY)
8T4060
8CC4070
(36' ONLY)
LEFT
8CC4072 RIGHT
(36' ONLY)
SECTION 2 – SET-UP OF DISK-CHISEL & COULTER-CHISEL WINGS (32’-40’)
2-23
NOTE: It is recommended to set up both sides of machine at the same time. The left hand side is
shown.
1. Attach wing to center section with pins, washers, bolts and locknuts.
– Washers are used to center wing in hinges and prevent shift.
2. Fasten cylinder attach brackets with 3/4” u-bolts, located 169” from machine center.
3. Insert eyebolts (8K1755) into cylinder attach bracket.
– Tighten 1-1/2” nuts so the same amount of threads are above top nut on all eyebolts. Insure
that cylinder attach holes are aligned when eyebolts are tightened.
4. Center liftarm under cylinder attach brackets.
– Use 3/4” u-bolts for 4x4 to attach liftarm pivots (8T4100) to frame.
– The inside pivot will be attached with 3/4 x 6” bolts and a trip assembly.
– Slide pivot pin (8T3640) through liftarm and liftarm pivots.
– Insert 7/16 x 3-1/2” bolt in retaining bolt hole. Secure with lock nut.