Summers Disk-Chisel - Manual (Page 86)

3-2
SECTION 3 – OPERATION
INITIAL HOOKUP
1. Make tractor to hitch connection with locking draw pin and safety chain.
2. Retract jack and rotate into storage position. Connect Safety Light Kit to 7 pin receptacle.
3. Plug wing lift hoses into desired tractor outlet. Insure that tips and couplers are CLEAN.
4. Plug depth control hoses into desired tractor outlet.
5. Park tractor and coulter-chisel on a level surface.
6. Remove transport lock pins on wings.
IMPORTANT
When the wings are setting against the transport locks and wing lift cylinders are fully re-
tracted, rollers and winglift pin on the rod end of the cylinder must be centered in the slot
on the wing. The 7” washers should be resting on the stand on top of the machine frame.
If this is not the case, the eye bolt holding the base end of the cylinder must be readjusted
accordingly. See drawing on page 3-3.