Summers Disk-Chisel - Manual (Page 47)

DEPTH CONTROL HYD 7/28/2010 9CC2412H.iam/
LEAVE ENOUGH
SLACK AT HITCH
PIVOT FOR FULL
RANGE OF TRAVEL
60" OF HOSE
(MIN)
LEAVE ENOUGH
SLACK FOR WING
TO PIVOT
1
2
SECTION 2 – HYDRAULIC SET-UP (24’ - 28’)
2-35
1. Hydraulic hoses and fittings for depth control cylinders can be found on following drawing.
– Rephasing cylinders require that oil from the rod end of first cylinder goes to base end of
second cylinder and so forth. Cylinders will not operate properly unless they are connected
correctly.
2. Special attention should be paid to routing of hydraulic hoses. Diagram below shows layout of
hoses for depth control cylinders.
A. It is best to start by routing the hose for the 6 x 10” cylinder. Make sure there is 60” of hose
ahead of hose holder. This is usually enough hose for safe and easy hook-up to tractor.
B. Route hose along hitch frame. Use plastic clamps provided. Do not tighten until routing is
complete.
– Clamps are made to have the round surface point towards the surface that you are
mounting to. DO NOT OVER TIGHTEN.
C. Leave slack by hitch pivot.