Summers Disk-Chisel - Manual (Page 90)

3-6
SECTION 3 – OPERATION
FIELD OPERATION
1. Rephase cylinders before starting field operation.
2. Choose a flat spot in a field to set tillage depth and level machine.
3. Determine desired tillage depth by working test strips within the field.
IMPORTANT!
The operator is responsible for adjusting machine since machine does not come “Field
Ready” from factory.
NOTE: Optimum performance of machine is achieved by tilling at a depth and moving at a
speed that does not go beyond limit of trip assemblies. This limit is exceeded if connecting
bolt (shown in the following drawing) continually rides above trip assembly cap.