Summers Superchisel - 5-Section - Manual (Page 40)

2-28
SECTION 2 – CONNECTING AND SEQUENCING WING LIFT
1. Charge wing lift cylinder system.
– Block rod end of cylinders up so that cylinder shafts can be extended without hitting any-
thing.
– Fully cycle cylinders several times to make sure that all air has been removed from the sys-
tem.
– Leave cylinders in fully extended position.
2. Connect rod end of 5 x 36” cylinders to part 1 wing.
– Install wing lift pin, rollers and washers onto the wing and cylinder rod tube. Secure pin with
8T3810 washer and roll pin.
– The 8L0250 1/4” thick washers must slide freely inside wing flamecuts.
– The drawing below shows an end view of this connection.
– Grease rod end tube on 5 x 36” cylinders before lifting wings. Also grease part 2 wing pivot
pins.