Summers Superchisel - 5-Section User Manual
Page 52
3-8
SECTION 3 – CHISEL PLOW OPERATION
5. Leveling the chisel plow from side to side. Stop the tractor with the machine still in the ground. Check
the depth of tillage on the left wing, center, and right wing. If leveling is necessary, use wrenches
provided to adjust the eyebolts on the cylinder attachments located at the rear of the machine.
*NOTE: Insure that cylinder attach holes are aligned when eyebolts are tightened.
One turn of the 1-1/2” NC Cylinder Attach Eye Bolt Nut changes chisel height 3/8”. One inch of ad-
justment moves chisel plow height over 2 inches. It may be necessary to move eyebolts a small
amount to attain correct adjustment of each section.
IMPORTANT!
Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on top
of the ground, shut tractor off and relieve pressure by cycling remote lever back and forth.