Important, Fig. 1, Fig. 2 – AquaStar 32" Channel Drain Pinhole Anti-Entrapment Suction Outlet Cover and Three-Port Manufactured Sump for Vinyl/Fiberglass User Manual
Page 10: Fig. 3
10
info
@
aquastarpoolproducts.com www.aquastarpoolproducts.com
877.768.2717 fax 877.276.POOL Outside the U.S.: +1.805.620.5060 fax +1.949.336.1940
IMPORTANT
• Model: 32PDxxx
• Single or multiple drain use
• At IAPMO (a nationally recognized
testing lab), the Propeller™ Drain 3/4”
sump and cover was tested with no
additional sump depth
• All AquaStar channel drains are
VGB 2008 compliant
• Plumbing to one or two pumps plus
skimmer equalizer are approved –
DO NOT exceed maximum flow rate
of outlet cover for total system
• One-pipe connection must be
minimum 2” pipe size and centered
along channel slot in sump
• Any plumbing configuration is
approved but do not exceed
maximum flow rate
• IMPORTANT: To be considered
unblockable, the Propeller™ drain
sump must be permanently and
securely affixed to become an
integral part of the pool floor using
epoxy (ie. Aquabond UW 5000)
around the entire edge and all of the
enclosed plastic anchors or optional
brass anchors.
32" PINHOLE ANTI-ENTRAPMENT SUCTION OUTLET COVER AND PROPELLER
MANUFACTURED SUMP - 32PDxxx INSTALLATION
The sump must be permanently and securely affixed to the pool floor using epoxy (ie. Aquabond UW
5000) under the sump and around the entire edge and all of the enclosed plastic anchors or optional
brass anchors. Once this is completed, the sump becomes a permanent part of the pool structure,
creating an unblockable drain. The drain cover is then affixed to the sump using the designated screws.
fig. 1
SINGLE PIPE CONNECTION CAN BE
ANY SIZE AND CENTERED ALONG
CHANNEL SLOT.
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
GRAVEL
SHOTCRETE/GUNITE
USE 1/4" MASONRY DRILL BIT AND INCLUDED
PLASTIC ANCHORS OR 5/16" DRILL BIT AND
OPTIONAL BIK4 BRASS ANCHORS
TWO-PART EPOXY
UNBLOCKABLE SUMP
PINHOLE ANTI-ENTRAPMENT
SUCTION OUTLET COVER
EPOXY OR SILICONE
fig. 2
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 1
GRAVEL
SHOTCRETE/GUNITE
UNBLOCKABLE SUMP
USE SCREWHOLES OF UNBLOCKABLE SUMP
TO POSITION DRILL
CENTER UNBLOCKABLE SUMP CHANNEL SLOT OVER PIPE
fig. 3
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 2
GRAVEL
SHOTCRETE/GUNITE
INSTALL SCREW ANCHORS (PLASTIC OR BRASS)
APPLY TWO-PART EPOXY TO UNDERSIDE OF
UNBLOCKABLE SUMP