32pdxxx installation continued, Important, Fig. 4 – AquaStar 32" Channel Drain Pinhole Anti-Entrapment Suction Outlet Cover and Three-Port Manufactured Sump for Vinyl/Fiberglass User Manual
Page 11: Fig. 5, Fig. 6
info
@
aquastarpoolproducts.com www.aquastarpoolproducts.com
11
IMPORTANT
• Model: 32PDxxx
• Single or multiple drain use
• At IAPMO (a nationally recognized
testing lab), the Propeller™ Drain 3/4”
sump and cover was tested with no
additional sump depth
• All AquaStar channel drains are
VGB 2008 compliant
• Plumbing to one or two pumps plus
skimmer equalizer are approved –
DO NOT exceed maximum flow rate
of outlet cover for total system
• One-pipe connection must be a
minimum 2” pipe size and centered
along channel slot in sump
• Any plumbing configuration is
approved but do not exceed
maximum flow rate
• IMPORTANT: To be considered
unblockable, the Propeller™ drain
sump must be permanently and
securely affixed to become an
integral part of the pool floor using
epoxy (ie. Aquabond UW 5000)
around the entire edge and all of the
enclosed plastic anchors or optional
brass anchors.
32PDxxx INSTALLATION CONTINUED
The sump must be permanently and securely affixed to the pool floor using epoxy (ie. Aquabond UW
5000) under the sump and around the entire edge and all of the enclosed plastic anchors or optional
brass anchors. Once this is completed, the sump becomes a permanent part of the pool structure,
creating an unblockable drain. The drain cover is then affixed to the sump using the designated screws.
fig. 4
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 4
GRAVEL
SHOTCRETE/GUNITE
TWO-PART
EPOXY
UNBLOCKABLE SUMP
AFFIX THE UNBLOCKABLE SUMP TO THE POOL FLOOR
USING THE INCLUDED #10 X 1" SCREWS
fig. 5
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 5
GRAVEL
SHOTCRETE/GUNITE
TWO-PART
EPOXY
UNBLOCKABLE SUMP
SEAL PERIMETER WITH
EPOXY OR SILICONE
fig. 6
PLASTER
32" PROPELLER DRAIN INSTALLATION INSTRUCTIONS
STEP 6
GRAVEL
SHOTCRETE/GUNITE
TWO-PART
EPOXY
UNBLOCKABLE SUMP
AFFIX THE PINHOLE ANTI-ENTRAPMENT SUCTION
OUTLET COVER TO THE UNBLOCKABLE SUMP USING
THE INCLUDED #10 X 3/4" SCREWS
EPOXY OR SILICONE