Town Mongolian Barbecue Small - Manual (Page 2)

FOOD SERVICE EQUIPMENT CO., INC. • 72 Beadel St. • BKLYN • NY 11222
INSTALLATION INSTRUCTIONS for MBR-36 and MBR-42 MONGOLIAN BARBECUE RANGES
only.
Your new MasteRRange equipment has been carefully engineered and constructed with the best
possible workmanship and materials to provide many years of satisfactory service. Proper installation
is vital if appearance and performance is to be achieved.
PLANNING AND SITE PREPARATION
FOLLOW THESE INSTRUCTIONS CAREFULLY! PLANNING THE INSTALLATION OF YOUR
MONGOLIAN BARBECUE RANGE IS IMPORTANT.
1. MBR installations are generally in the center of a cooking area with clear access on all sides.
Suggested clearance around the entire unit is at least three feet.
2. Materials such as wood, compressed paper and plant fibers that will ignite and burn, must not
be exposed near range. Local safety codes should be complied with in respect to fire hazard
avoidance.
3. The entire unit must be kept clear to avoid restriction of the air supply for combustion.
4. The unit must be installed in an area or room with sufficient fresh air supply to ensure proper
combustion. Given enough fresh air this unit produces exhaust gases within ANSI limits.
5. The gas supply line must be of adequate size to ensure maximum efficiency of the unit. A
supply pipe with a minimum of 1- 1/4 ” diameter and a minimum operating gas pressure of 6”
WC for natural gas or 10” WC for propane gas should be used.
6. Use of the supplied regulator is mandatory. The regulator must be installed in a location where
it remains cool and is accessible for pressure adjustment (ANSI Z83.11-1996 sect. 1.15.5).
Never install the regulator underneath or in the center of the unit.
7. Equipment should be under hood with adequate ventilation.
UNCRATING AND PLACING THE UNIT
Three or more people will be needed for this step.
1. Position crate next to the location that the unit will occupy. Uncrate the range. Place it in
position. Note position of gas feed line.
2. Carefully locate the range into desired position to avoid damage to adjustable legs. Be sure to
locate your unit with the clearances away from combustible construction as indicated on the
rating plate of the unit. Turn all three gas valve lever handles to “OFF” position. Check that
three valves face in the position desired by customer.
2
3/8 ” Female Gas Valve
(Item No. 226102F)
Safety, pilot out only
(Item No. 249011)