AGFA 1815 Copier - Manual (Page 39)

Preparations
3-7
Connecting the Cables
The machine has the connectors for connection with either network or directly to a computer.
Connecting the Network Cable
To connect the machine to a network, use an network cable (10Base-T or 100Base-TX).
1 Turn the power switch located on the rear side of the
machine off ({), and remove the power cord from the
outlet.
2 Connect the network cable to the network interface
connector at the rear side of the machine.
3 Connect the other end of the network cable to your network device (hub).
4 Make network settings on the operating panel. See page 3-10.
Connecting the Parallel or USB Cable
To connect the machine directly to your computer, use either a parallel cable or USB cable.
Notes • Use the USB cable that complies with Revision 2.0 of USB standard with a rectangular Type A
plug and a square Type B plug.
• The connecting the USB cable should be shielded and not be longer than 5 meters (16 feet).
1 Turn the power switch located on the rear side of the
machine off ({), remove the power cord from the outlet
and turn the power off to your computer.