ConnectPRO Master-IT PRO User Manual – Older model - Manual (Page 12)

12
Buzzers and Beeps
Whenever a command or event is initiated, either a buzzer or beep will
sound to indicate a successful or failed command.
A built-in buzzer generates a high-pitch beep for correct hot-key
command; otherwise, one low-pitch beep for error
Hot-Key Commands
T O S ELECT A P ORT :
In a single master configuration, press and release the left CTRL key
twice, followed by the keys that represent the number of the port that
has the computer.
For example, to select a computer that is connected to port 5, press
and release the left CTRL key twice, then press the #5 key once.
CTRL , CTRL , 5
In a cascade configuration (master/slave), press and release the left
CTRL key twice, followed by the number key that represents the port
on the master that is being used to daisy-chain, then press the
number key that represent the port on the slave that the computer is
connected to.
For example, to select a computer that is connected to port # 8 of a
slave, when port # 1 of the master is used to daisy-chain, press and
release the left CTRL key twice, then press and release the #1 key,
then press and release the #8 key.
CTRL , CTRL , 1 , 8