ConnectPRO Master-IT PRO User Manual – Older model - Manual (Page 19)

19
Troubleshooting
If at any time the Master-IT PRO behaves abnormally, Consult the
following table for possible solutions. As always, first verify that all cables
are connected correctly and securely, and that all power adapters
necessary are connected and functioning.
If a solution cannot be found in the table, send an email message to:
[email protected]. Be sure to clearly explain the symptoms and
provide the following information:
1. The serial number and model number of the Master-IT PRO unit.
2. Types of operating systems being used.
3. Types of computers being connected: PS/2 or AT/Serial.
4. Brands and models of mouse and keyboard being used.
5. Type of configuration: Single Master or Cascade (master/slave).
6. Name of the person or business that purchased the Master-IT PRO.
7. Contact information of the user who is experiencing the difficulties.
SYMPTOMS CAUSES SOLUTIONS
No OSD screen.
•
No power.
•
Loose monitor connection.
•
Monitor is not a multi-
synchronous type.
•
After rebooting the
computers, press and
release the left CTRL key
twice
•
Reconnect the monitor.
•
Use a multi-sync monitor.
Keyboard error on
boot.
•
Loose keyboard
connection.
•
Reconnect the keyboard
cable, then reboot.
Cannot access
computers in a
cascade
configuration.
•
A slave unit has more
ports than the master.
•
A slave unit has been
daisy-chained to a port
other than ports1~8 of the
master.
•
Power was installed to a
slave before the slave was
daisy chained to the
master.
•
Remove the slave that
has more ports than the
master and reconnect it
as the master.
•
Use only ports 1~8 of the
master for daisy-chaining.
•
Remove all power
sources and 3-in-1 cables
from the slave, then
reinstall the 3-in-1 cables
first, and the power
adapter last.
•
Press and release the
front panel reset buttons.
Keyboard strokes
remain in a shifted
state.
•
The computer was in
shifted state when was last
switched.
•
Press both SHIFT keys
for 5 seconds.
•
Remove and reinstall all
power adapters and 3-in-1
cables. First reinstall the
3-in-1 cables, then the
power adapters.