Wagner Power Painter Pro with EZ Tilt - Manual (Page 10)

English
10 © Wagner Spray Tech - All Rights Reserved
Spray Controls (Pro)
Power Painter Pro
Electronic Material Selector:
The spray pattern is controlled by the Electronic
Material Selector (a) and by the thickness of the
material.
If you are spraying thicker materials such as latex
paint, press the ‘Select’ button (b) until the indicator
light indicates ‘paint’.
If you are spraying thinner materials such as thinner
stains, press the ‘Select’ button (b) until the indicator
light indicates ‘STAIN’.
Electronic Speed Control:
The speed control is displayed by the three green
lights on the upper right side of the control panel (c).
The Power Painter Pro offers three speed levels
(LOW/MED/HIgH). The lower the speed level,
the closer you can get to your work and the less
overspray you will have.
Lower speed levels give you greater control but
require more time to cover an area. Depending
upon the thickness of the material or conditions, the
settings may need to be adjusted.
To adjust the speed setting, press the ‘SPEED’ button
(d) until your desired speed is reached. If the sprayer
is unplugged, the current speed and electronic
material selector setting will be “stored” and
remembered during restart.
Low Cup Level Indicator
• Applicable only when spraying in cup mode,
cup filled to MAx FILL.
• The low cup level indicator is displayed by
the two red lights on the bottom right of the
control panel (e).
When your cup is running out of material, the low
cup level indicators will begin blinking. You should
quit spraying and refill the container (see Cup Mode
Setup instructions, page 6). avoid running the
cup dry. an empty cup will allow air to become
sucked into the sprayer, which leads to globbing
and spitting.
note: Before you resume spraying, press and
hold the ‘Reset’ button (f) and the indicators
will reset and no longer blink. always reset the
indicators when the cup is full and you are ready
to resume spraying. Failure to reset the low cup
level indicators will result in the indicators not
functioning properly. The low cup level lights will
reset whenever the power cord is unplugged.
c a
d b
e
f