Wagner Power Painter Pro with EZ Tilt - Manual (Page 12)

English
12 © Wagner Spray Tech - All Rights Reserved
Practice Spraying
You will need:
• a scrap piece of wood or cardboard
IMPoRTanT - read before spraying
Priming the Sprayer
Once you are ready to spray, it may take 20 seconds for
material to spray after you pull the trigger.
The sprayer may sound choppy, while at the same time spit or
spray large globs briefly prior to the spray coming out in a fine
mist. This is normal.
Keep holding the trigger and material will come from the
sprayer in a fine mist.
Practice Spraying:
1. Turn the material select lever toward “PAINT”, or. . .
Press the ‘SELECT’ switch until the light indicates ‘PAINT’.
note: The “PAINT” setting will allow the sprayer to
prime faster.
2. If equipped -
Set the speed control to the highest setting.
3. Point the sprayer at a scrap piece of wood or cardboard,
and pull the trigger (approximately 10 seconds) until
material sprays evenly from the spray gun.
4. If equipped -
Adjust the material select lever as needed to achieve a
good spray pattern.
5. If equipped -
Adjust the material selector and speed control as needed
to achieve the desired spray pattern.
6. (a) - Bad spray pattern.
(b) - good spray pattern.
a)
b)
2
6
3
PAINT
LOW
LEVEL
SPEED
HOLD TO RESET LOW LEVEL
LOW
LEVEL
SPEED
HOLD TO RESET LOW LEVEL
1
or
PAINT STAIN
4 5