Spraying technique, 13 2 b a a b, English – Wagner Power Painter Pro with EZ Tilt User Manual

Page 13: Adjusting the spray tip assembly, Incorrect correct

Advertising
background image

English

© Wagner Spray Tech - All Rights Reserved

13

Spraying Technique

adjusting the spray tip assembly:

The adjustable spray tip assembly produces

a pattern that can be adjusted horizontally

or vertically. Rotate the spray adjustment

guard (b) as shown.

To prevent an injection hazard,

make sure the sprayer is

unplugged before you adjust the

spray tip. Make sure the spray

tip nut (a) is sufficiently hand

tightened prior to spraying.

Spraying Technique

Keep your arm moving at constant speed and

keep the sprayer at a constant distance from the

surface. The sprayer should be triggered at the

beginning of the stroke and released at the end

of the stroke.

*note: Slower speeds (if equipped) will allow

you to get closer to the spray surface.

Keep the sprayer at a consistent distance to

the surface. This means moving your entire

arm back and forth rather than just flexing

your wrist. Overlap each stroke by 50%.

IMPORTanT: If a large amount of material is leaking

from behind the adjustable spray tip assembly, turn

off the sprayer immediately or the sprayer could

be damaged. The sprayer will leak from behind the

adjustable spray tip assembly if the tip nut is not

tightened firmly. If you notice material leaking from

this area, follow the steps below.

1. Unplug the sprayer immediately.
Remove the adjustable spray tip assembly.

note: Remove the adjustable spray tip assembly by

turning the spray tip nut (a), not the spray adjustment

guard (b).

2. Remove the atomizer valve and see if it needs to be

cleaned or replaced (see page 20).

Also check the pump housing opening for any dirt or

other obstruction and clean if necessary.

3. Put the atomizer valve back in place, making sure it

can seat properly without any obstruction.

Thread on the adjustable spray tip assembly by

turning the tip nut clockwise and tighten firmly by

hand.

Spraying horizontally

(side to side):

Spraying vertically

(up and down):

Keep stroke

even

End

stroke

Start

stroke

Pull

trigger

Release

trigger

Move steadily

Aproximately

10 to 14 inches*

Incorrect

Correct

1

3

2

b

a

a

b

Advertising
This manual is related to the following products: