American Dryer Corp. PHASE 7.2.2 NON-COIN - Manual (Page 11)

9
E. LIGHT EMITTING DIODE (L.E.D.) DOT MATRIX DISPLAY
The L.E.D. display informs the user of cycle status, program verification, and displays important diagnostic and
fault information. A complete listing of the various display messages and their meanings is shown in Section V
of this manual.
CYCLE IN PROGRESS DISPLAY STATUS
During the Drying Cycle, the display will indicate the type of cycle in progress by presenting either one (1) of the
following:
1. “AUTO DRYING CYCLE” – Manually Loaded Auto Cycle.
2. “AUTO DRYING CYCLE #” – The “#” is replaced with “A-F” or “0-40”.
3. “MANUAL DRYING CYCLE” – Manually Loaded Manual Cycle.
4. “MANUAL DRYING CYCLE #” – The “#” is replaced with “A-F” or “0-40”.
F. CYCLE IN PROGRESS TEMPERATURE DISPLAY
While the dryer cycle is in progress, the temperature in the basket (tumbler) can be displayed by pressing and
holding the “UP ARROW” key. The temperature will be displayed in either Fahrenheit (°F) or Celsius (°C),
depending on which temperature system has been set in the “DRYER SETUP”.
G. TEMPERATURE CONVERSION STATUS
Temperature related programs are programmable to be operated in either Fahrenheit (°F) or Celsius (°C). The
temperature selection is made in “SYSTEM TEMP”. The programs affected are as follows:
1. Temperature Display Mode
2. Drying Temperatures
3. Cool Down Temperatures
IMPORTANT: When changing the temperature conversion status from Fahrenheit to Celsius, or vice
versa, ALL of the Temperature Selections and Cool Down Temperatures will be
changed accordingly. The Phase 7 non-coin microprocessor controller (computer)
automatically calculates and converts the temperatures in these programs to the
previously set value. For example, if the preprogrammed Cycle “A” drying
temperature was set for 160° F, when converting from °F to °C, the Phase 7 non-coin
microprocessor controller (computer) will change to 71° C (+/- 1° Celsius).