American Dryer Corp. PHASE 7.2.2 NON-COIN - Manual (Page 13)

11
K. REVERSING OPTION
This feature helps reduce balling-up or tangling of large items.
REVERSING OPTION SELECTIONS:
1. Reverse On or Reverse Off
2. This option can be set to “ON” or “OFF” for each cycle individually.
3. Basket (Tumbler) Spin Time and Dwell (Stop) Time
a. Fixed in the Automatic “AUTO” Mode and cannot be changed.
1) Spin Time – 2 minutes forward and 2 minutes reverse.
2) Dwell (Stop) Time – 5-seconds.
b. Programmable in the Manual Mode.
1) Spin Time – Programmable from 30-seconds to 120-seconds, in 1-second increments.
2) Dwell (Stop) Time – Programmable from 5-seconds to 10-seconds, in 1-second increments.
L. DIAGNOSTICS
The Phase 7 non-coin microprocessor controller (computer) monitors the “Drying Functions”, which include
temperatures, burners, sail switches, blower, basket (tumbler), and lint drawer.
M. PROGRAM LOCATIONS
System parameters are programmed in Program Locations (PL). Access to this location is acquired by pressing
the “STOP/CLEAR”
and the “UP ARROW” together. To exit the Programming Location, simply press
the “STOP/CLEAR” key. If you are several menu layers deep, continue to press the “STOP/CLEAR”
key to back up the menu until you are ALL the way out of the Programming Mode.
0. SELECT LANGUAGE – This menu allows the selection of five (5) different languages to operate the
dryer. The language that is selected will be used for every displayed message as well as for faults and
menus.
ENGLISH
FRANCAIS
ESPANOL
ITALIANO
DEUTSCH
1. SELECT SYSTEM PARAMETERS – This menu level has four (4) sections. ALL programmable
parameters, other than preprogrammed cycles, are done here.