American Dryer Corp. PHASE 7.2.2 NON-COIN - Manual (Page 26)

24
To alter the programming parameters, the operator will locate the parameter (program) that is to be changed. If
the change is numerical (i.e., time and/or temperature), the operator will simply enter the numerical value
desired. If an error is made, press the “STOP/CLEAR” key ONCE and the incorrect entry that was made
will be cancelled. Once the entry is made and the parameter (program) set does not need to be changed, press
the “START/ENTER” key, and the Phase 7 non-coin microprocessor controller (computer) will advance to
the next program selected.
If the parameter (program) change is a feature
change, such as changing the temperature conversion
from degrees Fahrenheit (°F) to degrees Celsius (°C)
or from “AUTO” (Automatic Drying Cycle –
[Patent No. 4,827,627]) to “MANUAL” (Timed
[Manual] Drying Cycle), the operator will press and
hold the “UP ARROW” or “DOWN ARROW”
key. This will toggle between choices. Once the
entry is made, or if the parameter (program) does
not need to be changed, press the “START/ENTER”
key and the Phase 7 non-coin microprocessor
controller (computer) will advance to the next
program selection.
When making numerical changes, please stay within
the programming limits shown. If an erroneous entry
is made, the Phase 7 non-coin microprocessor
controller (computer) will display “ERROR” and
ignore the entry made when the “START/ENTER”
key is pressed; it will return to the numerical value
previously set.
The Phase 7 non-coin microprocessor controller
(computer) allows the operator to scroll through the
various parameters (programs) and select the
parameter to be changed. At this point, the operator
can go to the next Program Location (system
parameter) to be changed. If no other programs
(parameters) need to be changed, the user can exit
the Program Mode by pressing the “STOP/CLEAR”
key until the Phase 7 non-coin microprocessor
controller (computer) is out of the Programming
Mode. The Phase 7 non-coin microprocessor
controller (computer) will be returned to the
Operating Mode, and the light emitting diode (L.E.D.)
display will read “READY”.