American Dryer Corp. PHASE 7.2.2 NON-COIN - Manual (Page 18)

16
7) Once the Cool Down Cycle is completed, the Phase 7 non-coin microprocessor controller (computer)
will proceed into the Wrinkle Guard Cycle. The Audio Alert tone will sound (for the amount set in
Audio Alert On Time). The light emitting diode (L.E.D.) display will read “CYCLE DONE”. The
dryer will wait an initial 15 minute delay before going into a 15-seconds ON, 5 minutes OFF cycle.
These times are fixed and are not programmable. During the ON Time, the blower (fan) and the
basket (tumbler) will start to rotate without heat for 15-seconds; during this time, the display will
read “WRINKLE GUARD”. After the 15-seconds are completed, the display will read “CYCLE
DONE” and the dryer will go into a 5 minute OFF cycle. The Phase 7 non-coin microprocessor
controller (computer) will repeat this process of 15-seconds “ON” and 5 minutes “OFF” until either
the doors are opened, the “STOP/CLEAR” key is pressed, or 99 minutes have elapsed, whichever
comes first. Once the 99 minutes have elapsed, the L.E.D. display will then read “CYCLE DONE”
and the Phase 7 non-coin microprocessor controller (computer) will lock out the dryer functions
until the doors are opened. The L.E.D. display will then return to “READY”.
2. Manually Loaded Cycles
a. Automatic Drying Cycle (Patent No. 4,827,627)
1) L.E.D. display reads “READY” (no cycle in progress).
2) Press AUTO key.
3) L.E.D. display will now read ENTER DRY TEMP 160 TO 200. (Defaults to 160° F [71° C]).
Enter the temperature desired (from 160° F to 200° F [71° C to 93° C] in one-degree increments).
I.E., for 180° F (82° C), press key “1”, key “8”, key “0”, and then press the “START/ENTER”
key to accept the value.
4) L.E.D. display will now read ENTER DRY LEVEL: finishing, dry, and extra dry. Enter the amount
of extraction (dryness level) desired. Finishing has the most moisture content, dry has less moisture
content, and extra dry has little or no moisture content.
5) L.E.D. display will now read “REVERSE MODE” (defaults to ON). The ON/OFF selection can
be toggled with the “UP ARROW” and “DOWN ARROW” . Once selected, press the
“START/ENTER” key to accept selection.
NOTE: In addition to entering a value by pressing the number keys, the “UP ARROW” and
“DOWN ARROW” can be used to scroll to the number desired, or to toggle between
selections.
6) At the start of a cycle, the L.E.D. display will initially display the cycle parameters of the selected
cycle: AUTO DRYING CYCLE, TEMP 180, DRYNESS LEVEL EX DRY. Then the display will
read: AUTO CYCLE, ELAPSED TIME 00:00 MINUTES. The L.E.D. display will continue to
show AUTO CYCLE, ELAPSED TIME XX:XX MINUTES, until the load is dried to the appropriate
dryness level or the auto cycle time out time has expired.
NOTE: Press and hold the “UP ARROW” to view the basket (tumbler) temperature at any time.
NOTE: The dryer can be stopped at any time by pressing the “STOP/CLEAR” key; at this time, the
dryer will go into a cycle pause. If the “STOP/CLEAR” key is pressed again at this point,
the cycle that was in progress will be cancelled and returned to the “READY” state.