Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 65)

Section 5. Programming
5-25
The display will respond with the message
“Terminate After 0000009 Samples”. The
numerical value will be whatever value was
last placed in the controller’s memory,
usually after previous programming. To
keep the previous value press ENTER, or,
to set a new value, use the ARROW keys to
advance the flashing prompt to the desired
location and replace the digits under the
prompt by using the digits (0-9) on the
Touchpad. Each new entry will
automatically advance the prompt to the next
location. In this way, the entire 7 digit
number can be changed. The ARROW keys
can be used to skip already correct digits, in
either direction.
When the 9 digit number is correctly
entered, press ENTER.
The display will echo the last entry with
PROGRAM TYPE <ENTERED>.
The controller has now been given a new
value for PROGRAM TYPE. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key,
then again press it to confirm your choice.
The controller will then be set to perform as
a Composite Sampler in conjunction with
the parameters programmed under the
START DELAY and SAMPLE
INITIATION variables.
Summary of Sequence:
SET, PROGRAM TYPE, ARROW(S), ENTER, #######, ENTER,
RESTART, RESTART.