Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 70)

Section 5. Programming
5-30
The display will show the response
“CONSECUTIVE Total Bottles nn“. The
two digits, nn, will be flashing, indicating
they can be changed by scrolling with the
arrow keys.
Press ENTER. The display now reads “nn
bottles per Sample Cycle”. A previously set
value will be displayed. One of the digits is
flashing. Using the number keys (0-9), enter
the first digit of the number of bottles that
will be used at each sampling time
determined by the programming setting, i.e.,
enter the number of samples to be taken at
each predetermined time. After the first
digit is entered, the second digit will flash
prompting for the remaining digit of the
entry. The sampler will repeat this quantity
each time the sampling is initiated, until the
“Total-Bottles” setting is reached.
Press ENTER. The display now shows
“PROGRAM TYPE <ENTERED>”.
The controller has now been given a new
value for PROGRAM TYPE. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key,
then again press it to confirm your choice.
The controller will then be set to perform as
a Consecutive Sampler in conjunction with
the parameters programmed under the
START DELAY and SAMPLE
INITIATION variables.
Summary of Sequence:
SET, PROGRAM TYPE, ARROW(S), ENTER, ENTER, ##, ENTER,
RESTART, RESTART.