Campbell Scientific PVS4100/4120/4150 Portable Automatic Samplers - Manual (Page 81)

Section 5. Programming
5-41
The display will show the response “FAULT
SHUTDOWN Enabled / Disabled”. All the
characters on the bottom line are flashing,
therefore the choice is made with the
ARROW keys. The choice is a toggle
between ‘Enabled’ or ‘Disabled’. If
disabled, the controller will make a lengthy
attempt to obtain a sample, then return
control to the SAMPLE INITIATION to
try again. The controller will accumulate a
count of unsuccessful (abandoned) attempts.
Press ENTER. The display now reads
FAULT SHUTDOWN <ENTERED>.
The controller has now been given a new
value for FAULT SHUTDOWN. The new
value resides in the NEW ENTRIES area of
the controller memory. To make these
changes active, press the RESTART key,
then again press it to confirm your choice.
The controller will then be set to perform in
conjunction with the parameters
programmed under the START DELAY,
SAMPLE INITIATION and PROGRAM
TYPE settings.
Summary of Sequence:
SET, OTHER OPTIONS, ARROW(S), ENTER, ARROW(S), ENTER,
RESTART, RESTART.