Campbell Scientific PC400 Datalogger Support Software - Manual (Page 155)

Section 8. Datalogger Program Creation with Edlog
Optimize (<F6>) – Deletes Input Locations that aren’t read, written to, or
marked as Manual. Optimize tries to reduce the total number of locations used
by moving existing Input Location labels to fill in unused locations. This
might change several Input Location numbers. Any changes in location
number made by the Optimize command are reflected in the Edlog program.
Insert Block (<F7>) – Inserts and labels a block of Input Locations and marks
them as “Manual”. The locations are labeled in the same manner as reps.
Esc – The escape key closes the Input Location Editor and updates the label
assignments in the program.
8.2.4 Input Location Anomalies
In most instances, Edlog will automatically assign Input Locations for
locations which are generated by the datalogger program. An example of this
is Edlog’s handling of Input Locations for the REPS parameter. Though only
one Input Location is specified, if REPS is greater than 1, additional Input
Locations are created by Edlog.
There are certain instructions that generate multiple Input Locations for which
Edlog does not automatically allocate Input Locations. The user should
manually allocate these locations in the Input Location Editor. These are:
• Instruction 15, Serial I/O with Control Port
• Instruction 23, Burst Measurement
• Instruction 49, Spatial Maximum
• Instruction 50, Spatial Minimum
• Instruction 54, Block Move
• Instruction 75, Histogram
• Instruction 80, Store Area
• Instruction 81, Rainflow Histogram
• Instruction 100, TDR Measurement
• Instruction 101, SDM-INT8
• Instruction 105, SDI-12 Recorder
• Instruction 106, SDI-12 Sensor
• Instruction 113, SDM-SIO4
• Instruction 118, SDM CAN
• Instruction 119, TDR100
• Instruction 120, Data Transfer to TGT
• Instruction 127, HDR Goes Status and Diagnostics
• Instruction 128, SHEF Data Transfer to TGT
• Instruction 139, Detailed Program Signatures
8-19