Campbell Scientific PC400 Datalogger Support Software - Manual (Page 50)

Section 5. Split
5.2 Getting Started
The most common use of Split is to separate array data collected on a particular
interval from a data file containing data output at several different intervals.
In the following example, hourly data are split from a data set that contains 15
minute, hourly and daily data. The data was collected from BirchCreek, a
CR10X datalogger. The CR10X was loaded with a program created by Edlog
named Birch.dld.
The 15 minute data, array 99, the hourly data, array 60, and the daily data,
array 24, are intermixed in the data file.
When Edlog compiled Birch.dld, it also created the Final Storage Label file,
Birch.fsl that lists the final storage locations for each data element.
5-2