Avocent DSR4010 - Manual (Page 25)

Chapter 2: Installation 19
4. Attach the keyboard, monitor and mouse connectors of the DSRIQ module
to a user port on your legacy KVM switch.
5. Connect the servers to your legacy KVM switch according to the
instructions included with the device.
6. Power cycle the legacy KVM switch to enable the cascade code.
7. Repeat steps 2-6 for all legacy KVM switches you want to attach to your
system as cascading switches.
To connect and power up your DSR:
1. Connect your network cable from the LAN port on the rear of the DSR to
your network.
2. Power up all attached systems.
To install your DSR software:
See the DSView Installer/User Guide that ships with your software.
NOTE: Your software registration key will be necessary for installing the DSAuth software used
with your DSR appliance. Internet Explorer 5.0 or higher and Java Runtime Environment JRE
1.4.[X] must also be installed to use the DSWebview components of the DSView software.