Avocent DSR4010 - Manual (Page 42)

36 DSR Installer/User Guide
To turn broadcasting off:
From the Commands dialog box, clear the Broadcast Enable checkbox.
Using Scan Mode
In scan mode, the DSR appliance automatically scans from port to port (server
to server). You can scan up to 16 servers, specifying which servers to scan and
the number of seconds that each server will display. The scanning order is
determined by placement of the server in the list. The list is always shown in
scanning order. You can, however, choose to display the server’s name or EID
number by pressing the appropriate button.
NOTE: Scanning is only available to the local user.
To add servers to the scan list:
1. If OSCAR is not open, press Print Screen. The Main dialog box will appear.
2. Click Setup - Scan. The Scan dialog box appears.
Figure 3.11: Scan Dialog Box
3. Determine the order within the list to add the server. If there are no servers
in the scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a server to the end of the list, place your cursor in the last server
entry and press the Down Arrow key.