Samsung SWD-M100ZKECLW - Manual (Page 16)

13
Note: It is recommended that you clean the windshield area prior to affixing
the suction cup. This clean surface helps to better adhere the Car Kit
and establish a secure bond.
4. Firmly clasp both pieces (now joined) and secure the
suction cup to the windshield (4).
• If you must remove and reposition the suction cup, pull on the
plastic release located at the top of the suction cup.
5. With the Car Kit secured to the windshield, carefully insert
the bottom of the Mondi into the cradle (5) and then snap it
back (6). This action secures the clasp at the top of the
cradle onto the top of the Mondi unit to hold in place during
driving.
Note: The Mondi is supported at the base of the unit and secured to the
cradle by the clasp at the top. Make sure the Mondi snaps into the
base and is secure prior to starting any car motion.
Removing the Mondi from the Car Kit
1. Gently pull up on the cradle’s clasp to release its grip on
the Mondi.
2. Carefully slide the Mondi up at an angle away from the
cradle.
Removing the Car Kit from the Windshield
1. Remove the Mondi from the Car Cradle.
Important!: You must FIRST remove the Mondi from the kit before continuing.
If you do not, the Mondi can fall out of the cradle and damage
upon impact with the floor.
2. Locate the suction cup release (plastic tab atop the suction
cup).
3. Firmly pull it out (away from the suction cup) until the
Suction Holder releases its grip from the windshield.
Warning!: Do not affix the Car Kit to either side windows as this can block
your view and hinder driving visibility.
SWD-M100.book Page 13 Monday, March 8, 2010 8:09 AM