Advantech PCM-9588 - Manual (Page 21)

11 PCM-9588 User Manual
Chapter 2
H
/W Installation
2.1.3 Jumper description
Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, you
connect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2 and 3. In this case you would connect either
pins 1 and 2, or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Table 2.4: JP8: LCD Panel Power Select
Part Number 1653003101
Footprint JH3X1V-2M
Description PIN HEADER 3*1P 180D(M) 2.0mm DIP SQUARE W/O Pb
Setting Function
(1-2) +V5
(2-3) +V3.3
Table 2.5: JP9: Backlight control select
Part Number 1653003101
Footprint JH3X1V-2M
Description PIN HEADER 3*1P 180D(M) 2.0mm DIP SQUARE W/O Pb
Setting Function
(1-2) PWM Control
(2-3) Voltage Control
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers. And when clearing CMOS, set the jumper back
to 3.0 V Battery On, before turning on the power supply.
1 2 3