Advantech PCM-9588 - Manual (Page 39)

29 PCM-9588 User Manual
Chapter 3
B
IOS Operation
! Run VGA BIOS if S3 Resume [Auto]
This item allows system to reinitialize VGA BIOS after system resumes from
ACPI S3 mode.
! Power Management [Min Saving]
This item allows user to select system power saving mode.
! HDD Power Down [Disabled]
This item allows user to determine the time of system inactivity, the hard disk
drive will be powered down.
Mode= Disabled or 1 min ~ 15 min
! Video Off Method [DPMS]
This item allows user to determine the manner is which the monitor is blanked.
! Video Off In Suspend [Yes]
This item allows user to turn off video during system enter suspend mode.
! Suspend Type [Stop Grant]
This item allows user to determine the suspend type.
! Modem use IRQ [3]
This item allows user to determine the IRQ which the MODEM can use.
! Suspend Mode [1 Hour]
This item allows user to determine the time of system inactivity, all devices
except the CPU will be shut off.
! HDD Power Down Mode [15 Min]
This item allows user to determine the time of system inactivity, the hard disk
drive will be powered down.
! Soft-Off by PWR-BTTN [Enabled]
This item allows user to define function of power button.
! Wake-Up by PCI card [Enabled]
This item allows user to defines PCI cards to wake up the system from the sus-
pend mode.
! Power On by Ring [Enabled]
This item allows user to define the system will resume by activating of modem
ring.
! USB KB Wake-Up From S3 [Enabled]
This item allows user to enable using a USB keyboard, and allow a keystroke to
wake up the system from power saving mode.
! Resume by Alarm [Disabled]
Min Saving Minimum power management. Suspend Mode=1 hr.
Max Saving Maximum power management. Suspend Mode=1 min.
User Define Allows user to set each mode individually.
Suspend Mode= Disabled or 1 min ~1 hr.
V/H SYNC+Blank This option will cause system to turn off vertical and hori-
zontal synchronization ports and write blanks to the video
buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.
Instant-Off Press power button then Power off instantly.
Delay 4 Sec Press power button 4 sec. to Power off.