Advantech PCM-9588 - Manual (Page 23)

13 PCM-9588 User Manual
Chapter 2
H
/W Installation
Codec '97) is Intel Corporation's Audio "Codec" standard developed by the Intel
Architecture Labs in 1997 and used mainly in motherboards, modems, and sound
cards.
2.2.2.3 Power connector (CN5)
PCM-9588 can support both ATX and AT power supply and it can use different power
cable make the choice.
1. ATX power supply: you need to use ATX power cable (PN: 1700001112 WIRE
ATX-20P(M)/12P(F)+3P-2.0MM 15CM)
ATX: 5 V STB, +5 V ± 5%, ± 12 V ± 5%, external 12 V option for LCD Inverter, PCI
& PCI-104 Plus.
2. AT power supply: you need to use AT power cable (PN: 1700006196 AT Power
Cable 12P/Big 4P*2 10cm)
AT: 5 V only to boot up, external 12 V option for LCD Inverter, PCI & PC/104
Plus.
2.2.2.4 Inverter connector (CN6)
PCM-9588 can provide +5V and +12V and signal to LCD inverter board via CN6.
2.2.2.5 VGA connector (CN8)
The DB15-pin female connector is provided for video monitors.
2.2.2.6 LVDS connector (CN9)
Low-voltage differential signaling, or LVDS, is an electrical signaling system that can
run at very high speeds over inexpensive twisted-pair copper cables. LVDS is a dif-
ferential signaling system, which means that it transmits two different voltages which
are compared at the receiver. LVDS uses this difference in voltage between the two
wires to encode the information.
CN9 is LVDS (Low Voltage Differential Signal) connector. You can connect to 48bit
LVDS LCD panel via CN9.
2.2.2.7 TTL Panel Connector (CN10, CN11)
PCM-9588 support TTL LCD and CN10 is TTL Panel High bits and CN11 is Low bits
Connectors.
2.2.2.8 LAN Connector (CN12)
For the LAN port, it equipped with 1 high performance ethernet port which are fully
compliant with IEEE 802.3u 100Base-T. It is supported by all major network operating
systems. For customer requirement, PCM-9588 also has giga LAN option and it is
also fully compliant with IEEE 802.3ab 1000Base-T.
2.2.2.9 HDD LED and POWER LED connector (CN13)
CN13 is a front panel connector to indicate power and HDD status.
2.2.2.10 LPT/FDD Connector (CN15)
PCM-9588 can support LPT or Floppy via CN15. LPT (Line Print Terminal) is the orig-
inal, yet still common, name of the parallel port interface on IBM PC-compatible com-
puters. It was designed to operate a text printer that used IBM's 8-bit extended ASCII
character set.