Connecting the lan cables – Allied Telesis AT-iMG6x6MOD Electronics Unit User Manual
Page 17
AT-iMG646MOD Installation Guide
Chapter 3: Installing the Gateway in the Enclosure
17
Caution
The grommet must be sealed so that the unit can operate correctly in an outside environment.
Connecting the LAN Cables
To connect the LAN cables, perform the following procedure:
1. Remove the grommet from the LAN cable entrance. (This step has already been done if you have
installed the phone cable.)
Note
Allied Telesis recommends that you fully wire all six ports to allow for easy service expansion in the
future.
2. Insert a UV-rated wire tie through the slots at the bottom of the entrance.
3. Connect the LAN cables to the RJ-45 ports on the gateway.
4. Secure the wires with a wire tie, as shown in Figure 11. (This step will include the telephone wires if you
have installed the phone wires.)
Figure 11. Connecting the LAN Cables (Phone lines omitted for clarity)
5. Cut a notch into the bottom of the grommet to accommodate the LAN cables (and telephone cable if it
has been installed) and reinsert the grommet.